Control All Wireless

2 MOMENTARY FUNCTIONS WITH OPTIONAL DOUBLE PULL WITH EXTENDED RANGE ANTENNA  $249.00

 

 

• 2 BUTTON REMOTE SYSTEM
• 1 BUTTON SINGLE FUNCTION LATCHING (PRESS THE BUTTON ONCE TO ACTIVATE PRESS AGAIN TO DEACTIVATE.
• SECOND BUTTON IS MOMENTARY SINGLE FUNCTION (HOLD THE BUTTON DOWN TO ACTIVATE, RELEASE TO DEACTIVATE)          UP TO 500' CLEAR LINE SITE OPERATION.
• Works with 6,12,or 24 volt DC systems

• $249.00

This controller includes the valve shown. Button 1 is a latching on/off function to open and close the valve. Button 2 is a optional momentary function which you can use for any momentary function you may need. This button with our optional ground relay kit can be used as an engine shut off function.

Unit is designed for air compressor air on / off control or water on / off control , comes with a Rainbird 1" model 100GB valve

$369.00

 

This controller priced WITHOUT THE VALVE. Button 1 is a latching on/off function to open and close the valve. Button 2 is a optional momentary function which you can use for any momentary function you may need. This button with our optional ground relay kit can be used as an engine shut off function.

Unit is designed for air compressor air on / off control or water on / off control. For water control applications a simple sprinkler valve can be used.

$249.00

4 BUTTON REMOTE SYSTEM. ALL FUNCTIONS MOMENTARY WITH EXTENDED RANGE ANTENNA (not shown) UP TO 500'

Works with 6,12,or 24 volt DC systems

$259.00

4 FUNCTION REMOTE WITH DOUBLE PULL ON ALL 4 CIRCUITS.

4 MOMENTARY CIRCUITS (HOLD BUTTON DOWN TO ACTIVATE RELEASE TO DEACTIVATE) ALSO ACTIVATES A ADDITIONAL CIRCUIT AT THE SAME TIME ANY OF THE 4 BUTTONS ARE DEPRESSED. HAS EXTENDED RANGE ANTENNA. $289.00

 

• CONTROLLER UNIT DESIGNED FOR GAS ENGINE DRIVEN DE-ICING EQUIPMENT SALT SANDERS
• CONTROLS SPREADER ON AND OFF AND SPEED, ENGINE START AND STOP, THROTTLE UP AND DOWN.
• THIS UNIT IS A VERY COST EFFECTIVE WAY TO REPLACE OR CONVERT EQUIPMENT TO WIRELESS.
• NO MORE BULKY, COSTLY CONTROLS AND WIRING OR CORRODED CONNECTIONS CAUSED BY SALT DAMAGE.
• THIS UNIT WILL WORK WITH ANY ENGINE DRIVEN SALT SANDER, SUCH AS WESTERN, HENDERSON, SWENSON, MEYER, SALT DOGG, BUYERS, DOWNEASTER ETC.
• UNIT HAS MANY OTHER APPLICATIONS WHERE THE FUNCTIONS ABOVE CAN BE APPLIED TO VARIOUS APPLICATIONS
• $349.00

6 MOMENTARY FUNCTION REMOTE KIT. NO DOUBLE PULL OR LATCHING CIRCUITS. COMES WITH 8 BUTTON TRANSMITTER AND EXTENDED RANGE ANTENNA ( BUTTONS 7,8 ARE NOT USED) IDEAL FOR TOW TRUCKS... WITH PTO DRIVEN PUMP. MANY OTHER USES. $249.00 

• 8 BUTTON REMOTE SYSTEM
• EXTENDED RANGE ANTENNA (up to 500' clear line site)
• ALL BUTTONS SINGLE MOMENTARY FUNCTIONS (HOLD THE BUTTON DOWN TO ACTIVATE RELEASE TO DEACTIVATE.)
• Operates at distances up to 500'
• Hundreds of 12 volt DC applications
• Comes with 8 button key chain remote, receiver with leads and wiring diagram
  Works with 6,12,or 24 volt DC systems
• $315.00

• 8 BUTTON REMOTE SYSTEM
•  EXTENDED RANGE ANTENNA (UP TO 500')
•  BUTTONS 1 AND 2 ARE ON OFF LATCHING (PRESS BUTTON ONCE TO TURN A FUNCTION ON, PRESS SAME BUTTON AGAIN TO TURN OFF)
• BUTTONS 3-8 ARE SINGLE MOMENTARY FUNCTIONS (HOLD THE BUTTON DOWN TO ACTIVATE A FUNCTION & RELEASE THE BUTTON TO DEACTIVATE) 
•  UP TO 500' RANGE CLEAR LINE SITE OPERATION
  Works with 6,12,or 24 volt DC systems
• $359.00

VARIABLE SPEED MOTOR CONTROLLER (LOW AMP)

 THE 600DCE WIRELESS MOTOR CONTROLLER PROVIDES RPM CONTROL FOR A SINGLE 2 POLE MOTOR THAT CAN OUT PUT UP TO 70 AMPS FOR UP TO 2 SECONDS AND A CONTINUOUS AMPERAGE OF 35 AMPS. THE SPEED OR RPM CONTROL IS DONE BY PROVIDING THE USER 5 OUTPUTS APPROXIMATELY 1/5 OF THE MAXIMUM MOTOR RPM THE 600DCE ALSO INCORPORATES A FULL RPM FEATURE THAT RUNS THE MOTOR AT FULL SPEED FOR 6-8 SECONDS AND THEN AUTOMATICALLY SHUTS OFF AND AN E-STOP.

 

$319.00

 

  The RF-600DC1 Wireless DC Motor Controller provides RPM control for a single, 2 pole DC motor that can output up to over 200 amps for up to 1 seconds and a continuous amperage of up to 80 amps. The speed or RPM control is done by providing the user 5 outputs, approximately 1/5 of the maximum motor RPM. The RF-600DC1 also incorporates a full RPM feature (Blast) that runs the motor full speed for 6 to 8 seconds and then automatically shuts off and an E-Stop.
  To protect the motor and electronics, the RF-600DC1 has built-in safety circuits. These include:
• Automatic shut down if motor is locked up. How this is done is if the receiver senses a current draw of more than 200 amps at start up for more than approximately 1000mS, the unit will shut down from 1 to 30 seconds.
• Automatic shut off if the current draw does not drop below 75 amps after 6 to 8 seconds. Once again, the receiver will shut down for 1 to 30 seconds. 

DUAL ELECTRIC MOTOR CONTROL

Use this control unit to control 2  DC electric motors, USE ON DC DUAL MOTOR SALT SANDERS ETC... ALLOWS 3 DIFFERENT SPEED SETTING ON EACH MOTOR 

$369.00

COMING SOON

HEAVY DUTY AMPERAGE DUAL ELECTRIC MOTOR WIRELESS CONTROL

$395.00

10 amp diode. We reccomend 1 10 amp diode per cicuit on the receiver. (If you have a 2 function remote you need 2 diodes...)

$1.00 each

1 button keyfob can only be used with receivers that have at least 5 functions, activates brown wire only. $29.99 

• CAN BE USED AS A REPLACEMENT OR SPARE TRANSMITTER.
• WILL NOT INTERFERE WITH YOUR ORIGINAL TRANSMITTER.
• EASILY PROGRAMMED.
• 1 IN 16 MILLION ADDRESS COMBINATIONS.
• UP TO 20 TRANSMITTERS CAN BE MATCHED TO 1 RECEIVER.
• $39.99

• CAN BE USED AS A REPLACEMENT OR SPARE TRANSMITTER.
• WILL NOT INTERFERE WITH YOUR ORIGINAL TRANSMITTER.
• EASILY PROGRAMMED.
• 1 IN 16 MILLION ADDRESS COMBINATIONS.
• UP TO 20 TRANSMITTERS CAN BE MATCHED TO 1 RECEIVER.
• $42.99

• CAN BE USED AS A REPLACEMENT OR SPARE TRANSMITTER.
• WILL NOT INTERFERE WITH YOUR ORIGINAL TRANSMITTER.
• EASILY PROGRAMMED.
• 1 IN 16 MILLION ADDRESS COMBINATIONS.
• UP TO 20 TRANSMITTERS CAN BE MATCHED TO 1 RECEIVER.
• $51.99