 |
No more than 14 amps at any given time can run through the receiver. For higher amp uses you must use relays, solenoids... with the unit.
REVERSE POLARITY CONTACTOR WIRING DIAGRAM
General information for all control kits:
WARNING READ THIS BEFORE YOU INSTALL THE UNIT
ALL UNITS ARE RE-TESTED THE DAY THEY ARE SHIPPED. IF THEY WORK HERE THEY WILL WORK WHEN YOU GET THEM.
WE RECOMMEND A ON OFF SWITCH BE INSTALLED ON THE POWER OR GROUND SOURCE OF THE RECEIVER.
WE HIGHLY RECOMMEND THE USE OF DIODES ON YOUR RECEIVER WIRES TO PREVENT ANY BACK FEEDING FROM DEVICES THAT THE RECEIVER WILL BE CONNECTED TO. IF POWER IS BACK-FED INTO THE RECEIVER IT WILL BURN OUT ONE OR MORE FUNCTIONS. IF YOU CREATE A SHORT YOU WILL BURN OUT ONE OR MORE FUNCTIONS. RECEIVERS CANNOT BE REPAIRED AS THEY ARE POTTED. WE WILL NOT COVER ANY RECEIVERS THAT HAVE BURNT OUT CIRCUITS. THERE ARE HUNDREDS OF APPLICATIONS FOR THESE UNITS. WE DO NOT PROVIDE APPLICATION DIRECTIONS OVER THE PHONE. IF YOU ARE UNSURE HOW TO MAKE THE WIRELESS UNIT WORK WITH YOUR APPLICATION SEEK THE ASSISTANCE OF SOMEONE THAT IS.
YOU MUST PROTECT THE UNIT FROM POWER SURGES OR YOU WILL BURN OUT THE CIRCUIT BOARD AND WILL HAVE TO PURCHASE A NEW RECEIVER.
BE VERY CAREFUL WHEN REPLACING THE WATCH BATTERY IN THE TRANSMITTER, DO NOT PRY IT OR YOU WILL BREAK THE BATTERY HOLDER.
1. Good (CLEAN) solid power and ground connections are required for operation (direct connection to the battery is recommended). An in-line on/off switch is recommended as a safety function and for battery draw when the unit is not being used.
2. Make sure the receiver is mounted in an area that is as open as possible for your application. Metal surrounding the receiver can result in intermittent operation.
Contact us at info@controlallwireless.com or call 763-682-4475
