Universal Salt Spreader Wireless Controllers - Single Electric Motor Spreaders

Single DC Electric Motor Salt Spreader Universal Wireless Remote Controller Kit

Salt Spreader Wireless Controller Conversion Kit - Single DC Motor Spreaders

Salt spreaders such as the Western Low Profile salt spreader model 500, 1000, 2500, or the Boss TGS 600 or TGS 1100 salt spreaders along with any other tailgate salt spreader operated by a single dc electric motor can easily be converted into a wireless remote control kit. With our wireless remote control conversion kits for salt spreaders, you'll be able to use our 600DCKIT to convert your salt spreader to wireless to the point where you'll simply plug your salt spreader into your 7 prong on the back of your truck and away you go. No more wiring from back to front of the truck. No more drilling into your dash and feeding thick wires throughout your plow truck cab. Plug it in, and you are provided with 500 feet of continuous and constant RF connection to your salt spreader from the comfort of your truck. Our 600DC wireless remote is a direct replacement for the Meyer Wireless remote control kit as well. Use our kit in place of Meyer Part # 63930, Swenson wireless remote controls and any other Salt Spreader Wireless Remote on the market. Not to mention any wired OEM remote can be replaced with our kit to provide 100% wireless.

Universal wireless remote controllers for salt spreaders that are operated with a single DC electric motor such as most tailgate salt spreaders and some hopper salt spreaders on the market today.

Showing all 7 results

This 600DC1 Wireless transmitter controller and wireless receiver can be used as a replacement for any other wireless controllers built for the same on the market today including Meyer Part #63930, Fisher spreader wireless, Snow-Way, Snow-Ex, or any other brand on the market today.  Most Make/Model of vehicles have the battery charging pin of the 7-prong trailer plug-in activated. Many Chevrolet’s will not have the wire connected and or the fuse not installed for this function. The wire for this may be under the fuse box under the hood or taped to the wiring harness near the brake booster. Install this wire per mfg. instructions and install the proper fuse. If your vehicle is not equipped with the battery charging wire, you may add this by running a 8 or 10 gauge wire from the battery to the terminal on the truck side 7 prong plug as shown in the provided diagram. You must install a 40-amp fuse at the battery. Note 2015 and up Ford F150 and Ford 2017 and up F250,350 trucks do not have live power at the 7-prong trailer plug to operate a spreader, must use Anderson plug quick disconnect. If you do not have proper power and ground to the wireless unit it will not operate. 95% of failures are on the truck side and or failed 7 prong connections, always verify power to the unit as a first step in diagnosing a problem. Simply remove the cover from the receiver unit and press the black button. If the red light blinks you have power to the unit if not it is on the truck-side.
$449.00
Wireless remote controller transmitter for the 600DC kit which converts your existing single electric motor salt spreader into a wireless controller transmitter, replacing all of your existing functions. This is only the wireless transmitter from that 600DCKIT, so be sure you already own that before purchasing this. Check the color on your older wireless transmitter before ordering your 600KEYFOB as older models will have the red ring which will require you to purchase the red ring antenna each time going forward. All newer boards have the blue ring antennas and will going forward for any new purchases of the 600DCKIT wireless remote controller transmitter/receiver salt spreader conversion.
$89.99
The wireless remote controller conversion kit, 600DCKIT , is a single 12volt motor variable speed controller has 5 pre-set speeds in approx 1/5th increments. Comes with transmitter with glow in the dark label, rubber boot and lanyard. Receiver unit, 7 prong cord to plug into your truck receiver hitch and seal tight connectors. This unit is commonly used on single motor tailgate mounted salt sand spreaders such as Meyer, Western Low Profile, Boss TGS, SaltDogg Tailgate, Hiniker, Swenson and more. Completely replaces Meyer Part # 63930 Wireless Remote Control Kit and is hundreds of dollars cheaper! Most brands of vehicles have the battery charging pin of the 7-prong trailer plug-in activated. Many Chevrolet’s will not have the wire connected and or the fuse not installed for this function. The wire for this may be under the fuse box under the hood or taped to the wiring harness near the brake booster. Install this wire per mfg. instructions and install the proper fuse. If your vehicle is not equipped with the battery charging wire, you may add this by running a 8 or 10 gauge wire from the battery to the terminal on the truck side 7 prong plug as shown in the provided diagram. You must install a 40-amp fuse at the battery. Note 2015 and up Ford F150 and Ford 2017 and up F250,350 trucks do not have live power at the 7-prong trailer plug to operate a spreader, must use Anderson plug quick disconnect. If you do not have proper power and ground to the wireless unit it will not operate.
$499.99
The 625DC is a universal salt spreader wireless transmitter and wireless receiver for single motor variable speed control with an extra latching on/off function to operate another apparatus such as vibrate, light, or any aux function. 24′ power ground wiring, dust caps, sealtite connectors quick connect Anderson plugs all sold separately or sold in the 625DCKIT.
$439.00
Replacement wireless transmitter from the Wireless Salt Spreader Kit 625DC for single engine DC engine salt spreaders with additional function such as aux, lights, or vibrate function. Sold with boot and lanyard to provide additional protection. Easily pair with your existing 625DCKIT to tie into your salt spreader wireless remote controller system.
$89.99
The 625DC KIT is a universal salt spreader wireless conversion kit for single motor variable speed control with an extra latching on/off function to operate another apparatus such as vibrate, light, or any aux function. Comes with 24′ power ground wiring, dust caps, sealtite connectors quick connect Anderson plugs and complete instructions.
$589.00
Replace your rubber boot and get a new keyfob for your 8 button wireless transmitter for any of our 8 function wireless remote control kits from Control All Wireless.
$15.00

Showing all 7 results